|
Who's Online
There currently are 5896 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Another excellent buy! File too clear and explanatory.
;
A manual hard to find. It was very helpful to restore my device.
;
I am very grateful for this manual. Without it could not repair my receiver.
;
excellent work as always you do cheap, fast net and clean. you do an incredible service......thanks!
;
Great Job even clear than the one before!!!! god organization- I'm always very satisfied
5 Place the gauge on the drive roller on the left hand side of the carriage, with the GO side facing the carriage, in the position shown below: Gauge Y B Gauge must be parallel to the center line of the Drive Roller
Drive Roller
6 With the gauge held in place, manually move the carriage over the GO side of the gauge. The ledge, indicated below, should easily pass over the GO side of the gauge.
WARNING
Make sure that the carriage is in the down position at all times when passing over the gauge.
Ledge If the ledge does not go over the GO side of the gauge, adjust the carriage to media distance ' page 7 13. 7 Remove the gauge and replace it on the drive roller with the NO GO side facing the carriage. 8 With the gauge held in place, manually try to pass the carriage over the NO GO side of the gauge. The ledge, indicated above, should not pass over the NO GO side of the gauge. If the ledge does go over the NO GO side of the gauge, adjust the carriage to media distance ' page 7 13. 9 Replace the Yellow cartridge in the carriage.
7 12
Calibrations and Adjustments
C4699 90000
|
|
|
> |
|